Your Pre-Inspection Agreement: Statute of Limitations

shutterstock_1057643954 3-2

statute of limitations Recently, a kitchen fire resulted in $100,000 in damages to a home inspection client’s property. Upon investigation, the inspection client discovered that a defective electrical component in the dishwasher, which was subject to a national recall, caused the fire.

A review of the state’s regulations showed that nothing requires a home inspector to document the model number or to determine whether an appliance was subject to recall. Furthermore, the American Society of Home Inspectors’ (ASHI) Standard of Practice (SOP) specifically excludes the requirement to identify recalled appliances.

“The inspector is NOT required to determine … whether items, materials, conditions and components are subject to recall, controversy, litigation, product liability, and other adverse claims and conditions.” (ASHI SoP § 13.2 A17, “General Exclusions”)

Despite all the evidence negating the inspector’s liability, the inspection client persisted in their claim against the inspector. But when they did, they faced an even bigger problem. The inspection took place six years ago. Their state’s statute of limitations is five years. Based on state law, the client’s claim was time-barred. Our claims team dismissed what could have been a difficult and expensive claim at no cost to the inspector.

What is a statute of limitations provision?

A statute of limitations provision limits a client’s ability to file a claim against a home inspector to a specific period of time. The purpose of such a statute is to deter clients from coming back with complaints after their inspection findings are relevant.

For example, one of our home inspectors received a claim for roof defects that manifested 18 years after the inspection. Since the average lifespan of a roof is 20 to 30 years, it’s no surprise that the inspection client’s roof had defects nearly two decades later.

Typically, these clauses appear in the same section as your notice requirements, which dictate how and when clients must tell you they have an issue.

The following is an example of a dispute resolution provision from our claims team:

Any action must be commenced within one (1) year from the date of the inspection. The inspector shall have no liability for any action commenced more than one (1) year after the date of the inspection.

Note that your clause does not need to explicitly call itself a statute of limitations. However, it does need to clearly state the amount of time a client has to make a claim and the repercussions for not meeting that deadline.

statute of limitations Where do statutes of limitations come from?

When including a statute of limitations provision in your pre-inspection agreement, it’s important to know your state’s laws. Most states have legislation or case law specifying the maximum time claimants must initiate legal proceedings. However, you shouldn’t take state statute of limitations at face value. Here are some important factors to consider:

  • Statutes of limitations can vary based on the type of claim. As such, it’s important to research what variations may exist in your state.
  • Some states have statutes of limitations specific to home inspectors. These inspector-specific statutes can override the state’s general statute of limitations.
  • Different states have different rules dictating how to enforce their statute of limitations. For example, some laws say that the statute of limitations begins on the day after you perform your inspection. Others start the clock based on when you deliver your inspection report. Still others go by the date the claimant knew or should have known of the defect.
  • Court rulings, too, can affect how or even whether a state statute will apply. In some situations, such case law trumps existing legislation.

Be sure to have the lawyer assisting you with your pre-inspection agreement check the state law regularly because these statutes can change.

Can you have a shorter statute of limitations in your contract?

statute of limitationsMany home inspectors wonder whether they can have a shorter statute of limitations in their contracts. For example, if the inspector lives in a state with a five-year contractual statute of limitations, can their pre-inspection agreement propose a one-year statute instead? By reducing the amount of time clients can make a claim, inspectors hope to minimize the number of claims they receive.

While it is possible to write a shorter statute of limitations in your contract, a shorter statute isn’t necessarily enforceable. For example, a judge my rule your statute unreasonably short and, therefore, unfair to the consumer. Additionally, some state laws prohibit people from shortening statutes of limitations. Before shortening your contract’s statute of limitations, consult a local attorney to ensure that you do not go against any laws.

Manage your risk against potential claims.

Don’t let clients bring claims against you long after your findings are relevant. Include a statute of limitations provision in your pre-inspection agreement to protect your home inspection business.

Worried about having the write statute worded correctly? Use our state-specific agreements to save yourself from potential headaches.

This article was published in the ASHI Reporter in August 2020. See how this story appears in print on pages 6-7 below.